Whirlpool WRF953CIHB Use and Care Manual download pdf (Page 27)

To remove and replace shelves:

1. Make sure adjustable shelf mounts are in the lower position

before removing shelves. Doors will need to be open at a

90˚ angle. If open wider, it will make it harder to remove the

shelves.

2. Remove the middle shelf or top shelf by lifting it up and out

of the shelf supports. Then pull the shelf forward and tilt down

to a vertical position. Turn the shelf at an angle and pull out of

the refrigerator.

NOTES:

■ You will need to remove the middle shelf rst before removing

the top shelf.

■ Innity-slide glass shelves should be pushed back in.

When tilted up, make sure glass does not slide to the back.

3. Remove the bottom shelf by lifting it up and out of the

shelf supports. Then pull the shelf forward and tilt up to a

vertical position. Turn the shelf at an angle and pull out of

the refrigerator.

4. Replace the middle and top shelves by putting the shelf in

the refrigerator at an angle with the shelf front down. Lift the

front of the shelf up and in until rear shelf drops into the shelf

supports. Lower the front of the shelf and make sure that the

shelf is in position.

5. Replace the bottom shelf by putting the shelf in the

refrigerator at an angle with the shelf up. Lift the front of

the shelf down and in until rear shelf drops into the shelf

supports. Lower the front of the shelf and make sure that

the shelf is in position.

Platter Pocket Removal

To remove and replace pull-out platter:

NOTE: Refrigerator doors will need to be removed to remove

platter pocket. See the “Remove and Replace Refrigerator

Doors” section for more information.

1. Pull the pull-out platter to the fully open position or when

it stops.

2. Locate the pull-out platter retention clips on both sides.

These are in the side under the pull-out platter.

3. Push the clip up from the bottom with your nger.

4. After both clips have been disengaged, carefully remove

the pull-out platter toward the front of the refrigerator.

Crisper Drawers

To remove and replace the drawers:

1. Grasp the handle at the bottom of the drawer and slide the

drawer straight out to the stop. Lift the drawer off the bottom

guide.

2. Replace the drawer by placing it on the bottom drawer guide

and pushing it past the drawer stop into position.

To remove the crispers cover (can remove only if pull-out

platter is removed rst):

1. Remove the pull-out platter rst.

2. Holding the glass insert rmly with one hand, press up in

center of glass insert until it rises above the plastic frame.

Gently slide the glass insert forward to remove.

To replace crisper(s) cover:

1. Remove the crisper pan, pull-out platter, and crisper glass

before removing the crisper.

2. Fit back of cover frame into supports on side walls of the

refrigerator and lower the front of the cover frame into place.

3. Slide rear of glass insert into cover frame and lower front into

place.

Refrigerator Door Bins

The bins on your refrigerator door are adjustable to meet your

individual storage needs. The gallon-size bins make it easy to

customize door storage to hold gallon containers.

Door Bin Divider (on some models)

This divider ts in the door bin to divide the bin and elevate

smaller items at the back of the bin.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 80 81

Comments to this Manuals

No comments

Whirlpool WRF953CIHB Use and Care Manual Page 27

Comments to this Manuals

Related products and manuals for Fridges Whirlpool WRF953CIHB