Whirlpool WRF954CIHZ Use and Care Manual download pdf (Page 18)

3. Move the refrigerator to its nal location.

4. Using the 1/4" hex driver, lower the brake feet. Turn them

clockwise until the rollers are off the oor and both brake feet

are snug against the oor. This keeps the refrigerator from

rolling forward when opening the refrigerator doors or freezer

drawer.

IMPORTANT: If you need to make further adjustments

involving the brake feet, you must turn both brake feet the

same amount to keep the refrigerator level.

5. Use a level to make sure the refrigerator is level from side to

side and front to back.

6. Make sure the doors are even at the top and that the space

between the bottom of the refrigerator doors and the top of

the freezer drawer is even. If necessary, align the doors.

To Align the Doors:

■ Keeping both refrigerator doors closed, pull out the freezer

drawer. Locate the bottom hinge pin of the right-hand

refrigerator door. The alignment screw is inside the bottom

hinge pin.

■ Insert the short end of the 1/8" hex key (packed with the Door

Handle Installation Instructions) into the bottom hinge pin

until it is fully engaged in the alignment screw.

To raise the refrigerator door, turn the hex key to the right.

To lower the door, turn the hex key to the left.

■ Continue to turn the alignment screw until the doors are

aligned.

A. Bottom hinge pin

B. 1/8" hex key

7. Make sure the refrigerator is steady. If the refrigerator seems

unsteady or rolls forward when a door or drawer is pulled

open, adjust the brake feet.

To Steady the Refrigerator:

■ Open the freezer drawer. Using a 1/4" hex driver, turn

both brake feet clockwise the same amount until the

brake feet are snug against the ﬂoor. Check again. If you

are not satisﬁed, continue to adjust the brake feet by

half turns of the screw until the refrigerator does not roll

forward when the drawer is opened.

NOTE: Having someone push against the top of the

refrigerator takes some weight off the brake feet. This makes

it easier to turn the screws. Do not push with excessive force

that tilts the refrigerator.

8. Replace the base grille by aligning the ends of the grille with

the leveling assemblies on each side and snapping the grille

into place. Use a 1/4" hex driver to reinstall screws.

FILTERS AND

ACCESSORIES

Water Filtration System

Do not use with water that is microbiologically unsafe or

of unknown quality without adequate disinfection before

or after the system. Systems certified for cyst reduction

may be used on disinfected waters that may contain

filterable cysts.

Replace and Install the Water Filter

The water lter should be replaced every 6 months based on a

ow rate of .50 gpm-.60 gpm that lters 200 gallons of water.

To order a replacement lter, contact us. See the “Accessories”

section in the Use & Care Guide for information on ordering.

1. Push the water lter door to open, located bottom left of

refrigerator compartment.

2. Twist the water lter and turn 90° counterclockwise to unlock.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 123 124

Comments to this Manuals

No comments

Whirlpool WRF954CIHZ Use and Care Manual Page 18

Comments to this Manuals

Related products and manuals for Fridges Whirlpool WRF954CIHZ