Whirlpool WRT541SZDB Use and Care Manual download pdf (Page 8)

4. Assemble the parts for the top hinge as shown. See Top Hinge

graphic. Do not tighten screws completely.

Contour Door Models Only:

■ Remove the screw attaching the hinge pin to the hinge.

Turn the hinge over so that it is pointing in the opposite

direction.

■ Place the plastic spacer beneath the hinge so that it will

be between the hinge and the cabinet, making sure the

holes are aligned.

■ Fasten the top hinge to the opposite side of the cabinet,

inserting the screws only halfway, so you will be able to

replace and align the freezer door later.

5. Line up the doors so that the bottom of the freezer door aligns

evenly with the top of the refrigerator door. Tighten all screws.

NOTE: The distance between the doors should be

approximately ⁵⁄₈" (16 mm).

Final Steps

1. Check all holes to make sure that hole plugs and screws are in

place. Reinstall top hinge cover. See Top Hinge graphic.

2. Remove the cover from the base grille. Move the cover to the

opposite side.

3. Align the clips on the base grille with the screws on the

bottom of the cabinet. Push the base grille toward the cabinet

until it is flush.

4. Plug into a grounded 3 prong outlet.

5. Reset the controls. See “Using the Control(s).”

6. Return all removable door parts to doors and food to

refrigerator.

A. Plastic spacer

B. Hinge pin screw

C. Hinge pin

ACC

Electrical Shock Hazard

Plug into a grounded 3 prong outlet.

Do not remove ground prong.

Do not use an adapter.

Do not use an extension cord.

Failure to follow these instructions can result in death,

fire, or electrical shock.

WARNING

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 63 64

No comments

Whirlpool WRT541SZDB Use and Care Manual Page 8