Whirlpool TU 4100 Owner's Manual download pdf (Page 10)

Operation & Maintenance

Turn the hydraulic power on and pull the control valve

handle to the UNLOAD position (see sketch to the right).

The floor may begin to move erratically at first while it is

clearing out air pockets, but after a few seconds should

begin to sequence properly. Look for the following

indications that the floor is operating properly in UNLOAD

position:

1. Left side/front shaft and cross-drive move forward.

2. Center shaft and cross-drive move forward.

3. Right/rear shaft and cross-drive move forward.

4. All shafts and cross-drives move rearward together.

Cycle repeats...

Move the control handle to the NEUTRAL position:

The floor should not move.

Turn and push the control handle to the LOAD position

(two-way models only). Look for the following indications

that the floor is operating properly in LOAD position:

1. Right side/rear shaft and cross-drive move rearward.

2. Center shaft and cross-drive move rearward.

3. Left side/front shaft and cross-drive move rearward.

4. All shafts and cross-drives move forward together.

Cycle repeats...

UNLOAD Position: Pull the

handle all the way out.

NEUTRAL Position: Push the

handle in until it hits

the valve body

LOAD Position (Two-Way):

Turn the handle forward

and push it all the way in.

DANGER

Damaged or cut hydraulic hoses,

fittings or tubing. A small hole in a

hose or fitting will produce a stream of

fluid that can pierce the skin injecting

oil into your blood.

The space between cross-drive beams.

The space between shoe ends and

the subdeck ends.

The end of the slats and the front wall.

Avoid these hazards when the

floor is moving:

Unloading

Neutral

Doc # 99-5846-A

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 29 30

Comments to this Manuals

No comments

Whirlpool TU 4100 Owner's Manual Page 10

Comments to this Manuals

Related products and manuals for Trash Compactor Whirlpool TU 4100