Whirlpool CGD9150GW Installation Guide download pdf (Page 18)

1. Remove red cap from gas pipe on back of dryer.

2. Connect gas supply to dryer. Use a pipe thread compound

approved for the type of gas supplied. If exible metal

tubing is used, be certain there are no kinks.

If necessary for service, open the front lower service panel

by using a 1/4" nutdriver to remove the 2 hex-head screws

from the bottom of the panel. Then lift up on the panel while

pulling the bottom of the panel away from the dryer.

3. Open the shut-off valve in the gas supply line and make sure

the dryer has its own gas supply opened.

4. Test all connections by brushing on an approved

noncorrosive leak-detection solution. Bubbles will show

a leak. Correct any leaks found.

Make Gas Connection

INSTALLATION INSTRUCTIONS – GAS DRYER

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 63 64

No comments

Whirlpool CGD9150GW Installation Guide Page 18