Drain hose to waste tee.
cut hose
-connector
t
20”
minimum
clearance
to floor
If local plumbing codes permit, dish-
washer drain hose may be connected
directly to waste tee*. The waste tee
connection MUST be made ahead of
the trap and a minimum of 20 inches
above the floor.
Drain hose to disposer.
If local plumbing codes permit,
dishwasher drain hose may be
connected directly to disposer. Most
disposers have 7/8” connectors or
special connectors are available at
plumbing supply houses.
Knock out disposer
inlet plug from inlet
If inlet plug falls
inside disposer,
you must remove
inlet plug before
connecting drain
hose. If disposer is
already installed in
sink, you may need to take
out disposer to remove inlet plug.
‘All parts are available through your dealer or
local hardware or plumbing store.
CAUTION:
Do Not solder water supply line within
6 inches of plastic water inlet valve.
Failure to follow this instruction could
result in product damage.
12
n
Connect water pipe or
tubing directly to water inlet valve. Do
Not run pipe or tubing across front of
motor or dishwasher legs. Turn on water
supply and check for leaks.
13
n
Check electrical
requirements. Be sure you have correct
electrical supply and recommended
grounding method. See Panels A and B
for proper connection.
Top mountina brackets attached
to’undersideof countertop.
Phillips-
head
screws
No.-
Do Not
drop
screws
into
i
Door and
access and
toe panels
not shown.
14
w Open dishwasher door and
remove all shipping materials. Remove
bottom rack. Place a newspaper, large
sheet of paper or a towel over bottom
of dishwasher to prevent screws or other
items from dropping into the pump area
when securing dishwasher to
countertop.
Personal Injury Hazard
l
The dishwasher must be secured to
the countertop to keep it from
tipping when door is open.
l
Do Not drop screws in dishwasher
tub. If screws should fall into pump
area, pump and motor damage
may occur.
Failure to follow these instructions
may result in personal injury or
product damage.
15
n
Secure dishwasher to counter-
top with two, No.-1 0 x l/2” Phillips-head
screws from parts bag. You MUST secure
dishwasher to keep it from tipping
forward when door is opened or closed.
Do Not drop screws in dishwasher tub.
Remove paper or towel from bottom of
dishwasher.
equally spaced
\ ‘=“=’
I
16
w Open door approximately
3 inches and check for equal spacing
between inner door and tub sides. If
necessary, loosen screws that fasten
dishwasher to countertop and shift tub.
Tighten screws.
17
n
Check door for proper
operation. Door should close easily
without slamming and open with its own
weight. If necessary, close door and
adjust both door springs by moving
spring ends to different holes in base.
18
w Take a few minutes to read
19
n
Check that all Darts have
been installed and no steps were
skipped. Check that you have all the
tools you started with.
20
I Turn on electrical supply.
Start dishwasher and allow it to
complete a cycle. Check that
dishwasher is working properly and that
there are no water leaks.
Electrical Shock Hazard
l
Reinstall grounding clip over edge
of access panel.
l
Attach toe panel, access panel
and grounding clip tightly to
dishwasher leg.
Failure to follow these instructions
may result in death or serious injury.
lgrounding clip
Make sure this clip is
21
attached to access panel.
w Reattach the toe panel and
access panel. Check that grounding
clip is attached to the access panel. The
bottom edge of toe panel must be
positioned to contact floor.
22
n
If changing color of door and
access panel or installing custom
panels, follow the ‘To change door
panel color” and ‘To change access
panel color” instructions, Panel E and
back cover.
Congratulations!
You have just finished insfalling
your new undercounter
dish washer. Keep Installation
lnstrucfions available for easy
reference.
the Use and Care Guide to fully
understand your new dishwasher.
Panel D
Comments to this Manuals