6
Snap one end of retainer into
W channel as shown. Push inward
while sliding thumb along full length of
retainer.
7
n
Check door for proper
operation. Door should close easily
without slamming and open with its
own weight. If necessary, close door
and adjust both door springs by moving
spring ends to different hoes in base.
8
n
Push up with
thumbs on each end
of access panel top ’
trim to unsnap trim.
w
Remove top trim and set it aside.
9
n
Carefully
slide color access
panel and spacer
upwards and
remove. Save color access panel and
spacer for future use.
Part No. 3369679 Rev. B
01995
10
w Insert wood access panel into
access panel frame. Slide panel down
into groove along bottom of access
panel frame. It may be necessary to
remove the two screws securing top of
access panel to dishwasher frame and
tilt access panel forward to install some
wood panels.
II
n
Line up
edges of top trim
with sides of access
panel frame. Tilt
back of trim down
and slide into place. Snap front of trim
down to cover top edge of wood
access panel.
Benton Harbor, Ml 49022
Is not operating
properly.. .
Check these points:
l
Is the door closed tightly and
latched securely?
l
Has the cycle been set correctly to
start the dishwasher?
l
Is the water turned on?
l
Has a house fuse blown or circuit
breaker tripped?
l
Has electrical power been
interrupted?
Note: If the motor has stopped
because of overload, it will
automatically reset itself within a few
minutes. If after checking these points
the dishwasher still does not run or
complete a cycle, call for service.
If you need
as&stance...
Check your Use and Care Guide for a
toll-free number to call or call the dealer
from whom you purchased this
appliance. When you call, you will need
the dishwasher model number and
serial number. Both numbers are
located on the serial/rating plate
located behind the door on the front
frame of the dishwasher opening.
Printed on recycled paper.
10% post consumer waste/
50% recovered materials.
Printed in U.S.A.
Comments to this Manuals