Whirlpool GARF30FDGB Use and Care Manual download pdf (Page 6)

Electrical Requirements

WARNING

Electrical Shock Hazard

Plug into a grounded 3 prong outlet.

Failure to follow these instructions can result in

death, fire, or electrical shock.

Do not use an extension cord.

Do not use an adapter.

Do not remove ground prong.

Removing the Unit Door (optional)

This unit comes from the factory with a right swing door. If desired, follow these steps to reverse to a left-swing door.

IMPORTANT:

■ Depending on the width of the opening, you may need to remove the handle or door to move the unit into the house.

■ All graphics referenced in the following instructions are included later in this section after the “Final Steps” section. The graphic

may be reversed if the door swing is reversed.

■ Before you begin, turn the control off, remove food, and adjust the door or utility bins from door.

Replacing the Unit Door (optional)

Replace the bottom hinge parts from step 2 onto the unit. Then replace the rest of the hinge parts and the door from step 1.

Remove the four hex-head hinge screws and bottom hinge

assembly.

NOTE: Provide additional support for the door while the

hinges are being moved. Do not depend on the door magnets

to hold the door in place while you are working.

Unplug the refrigerator or freezer or disconnect the power.

Keep the unit door closed until you are ready to lift it free from

the cabinet. Remove the parts for the top hinge. Lift the unit

door free from the lower hinge and cabinet and set aside.

1. Remove Hinge Parts And Door 2. Remove Bottom Hinge Parts

Before you move your refrigerator or freezer into its ﬁnal location,

it is important to make sure you have the proper electrical

connection.

Recommended Grounding Method

A 115 Volt, 60 Hz., AC only, 15 or 20 amp fused, grounded

electrical supply is required. It is recommended that a separate

circuit serving only your refrigerator or freezer be provided. Use

an outlet that cannot be turned off by a switch. Do not use an

extension cord.

NOTE: Before performing any type of installation, cleaning, or

removing a light bulb, press and hold TEMP SETTING for

3 seconds to turn off cooling, and then disconnect the

refrigerator or freezer from the electrical source.

A. Top Hinge Cover

B. 5/16" Hex-Head Hinge Screws

C. Top Hinge

A. Hinge Pin

B. 3/8" Hex-Head Hinge Screws

1 2 3 4 5 6 7 8 9 10 11 ... 55 56

Comments to this Manuals

No comments

Whirlpool GARF30FDGB Use and Care Manual Page 6

Comments to this Manuals

Related products and manuals for Fridges Whirlpool GARF30FDGB