Whirlpool Automatic Ice Maker User Manual download pdf (Page 11)

Wiring Harness Plugs

Fig. 3-2

Fig. 3-3

Disconnect the three wiring harness plugs from the connectors at the bottom of the control

box.

(Fig. 3-3)

3. Remove the Hex-head screw securing the

cutter grid mounting bracket to the right

side of the cabinet liner.

(Fig. 3-4)

4. Loosen, but do not remove the Hex-head

screws securing the cutter grid mounting

bracket to the left side of the cabinet liner.

(Fig. 3-4)

Then, lift the front of the cutter

grid up to release the Hex-head screw

from the key slot in the left side mounting

bracket and pull the cutter grid from the

cabinet.

5. Remove the four (4) Hex-head screws

securing the control box to the top of the

ice maker cabinet.

(Fig. 3-5)

NOTE: The screws at the front of the

control box are recessed.

Three (3) Screws

Fig. 3-4

Remove

This

Screw

Loosen

This Screw

ACCESSING THE COMPONENTS IN THE CONTROL BOX

(This procedure is the same for long and short door units.)

Removing the Control Box

1. Remove the three (3) Phillips-Head screws securing the cutter grid cover to the cutter grid.

(Fig. 3-2)

Fig. 3-5

6. The control box can now be lowered into

the service position.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 33 34

No comments

Whirlpool Automatic Ice Maker User Manual Page 11