Whirlpool Automatic Ice Maker User Manual download pdf (Page 12)

Removing the Electronic Control Board

1. With the control box in the service position, disconnect the three (3) wiring harness plugs from

the connectors on the electronic control board.

(Fig. 3-9)

2. Remove the two (2) Hex-head screws securing the electronic control board to the mounting

stubs in the control box.

(Fig. 3-9)

Wiring Harness

Plug

Wiring Harness

Plug

Wiring

Harness

Plug

Fig. 3-9

Removing the Push Button Switch Assembly

The push button switch assembly can be removed with the control box remaining in the service posi-

tion.

1. Disconnect the wires from the switch assembly terminals.

2. Remove the decorative overlay from the front of the control box.

(Fig. 3-10)

3. Press in on the four locking tabs at the back of the switch assembly and push the entire switch

assembly.

NOTE: If the push button switch assembly must be replaced, the service replacement

assembly must be ordered by using the specific model number of the ice maker. The

service replacement switch assembly comes with a new decorative overlay.

Fig. 3-10

Decorative

Overlay

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 33 34

No comments

Whirlpool Automatic Ice Maker User Manual Page 12