Whirlpool Automatic Ice Maker User Manual download pdf (Page 13)

Removing the Condenser Fan

1. Remove the two (2) Hex-head screws securing the condenser fan assembly to the condenser

and the two (2) Hex-head screws securing the condenser fan assembly to the component

compartment base.

(Fig. 3-16)

2. Remove the three (3) hex-head screws securing the fan motor to the fan bracket.

(Fig. 3-17)

ACCESSING THE COMPONENT COMPARTMENT

1. Open the ice maker door and remove the

four (4) Phillips-Head screws securing the

component compartment front cover to

the cabinet.

(Fig. 3-14)

2. Pull the ice maker from its installed

position. It may be necessary to disconnect

the water supply line and drain line from the

ice maker.

3. Turn the front leveling legs out until they

disengage from the cabinet.

(Fig. 3-14)

4. Remove the two (2) front bolts securing

the component compartment base to the

cabinet.

5. Tilt the entire ice maker cabinet back far enough to gain access to the component compart

ment.

(Fig. 3-15)

Be careful not to kink any of the sealed system tubing or pinch any wiring

while tilting the cabinet backward.

NOTE:Secure the cabinet to avoid any possibility that it will tip back any further or fall

forward while repairs are being performed.

Screws

Fig. 3-14

Fig. 3-15

Fig. 3-16

Screw

Fig. 3-17

Leveling Leg

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 33 34

No comments

Whirlpool Automatic Ice Maker User Manual Page 13