Whirlpool AMD 383 Instruction for Use download pdf (Page 17)

CLEANING AND MAINTENANCE

Before inspection and maintenance of the unit, Please turn off the unit and set the power switch to "OFF"

to cut off the power supply

Just professional people could clean or replace the filter.

Before open grill to clean filter, the power must be cut off and wait for the fan motor stop.

CLEANING THE AIR FILTER

Remove the air filter; clean it by a vacuum cleaner or if it is very dirty, wash it with soap water then wipe

off until it is completely dry before reinstallation.

SUGGESTION:

• If the air filter is dirty, it will cause the reduction of airflow. The unit is overloaded and consumes 6%

more of electricity.

• Clean the air filter every week for higher efficiency.

CLEANING THE UNIT

Clean the air conditioner and the remote control with dry cloth or a vacuum cleaner. If damp cloth is

used, remove moisture by using dry cloth afterward.

CAUTION

• Do not use benzine gasoline, thinners or polishing products for cleaning.

• Do not wash with hot water (above 40°C). Some parts of the unit may be deformed.

AT THE START OF THE SEASON

• Check that nothing blocks the air inlet and outlet of the indoor and outdoor units.

• Running the unit without air filters can cause malfunctions due to dirt or dust. Always install air filters at

all times.

• Check that drainage hose is not bent or clogged.

• Check that the units are properly installed.

DURING THE OFF SEASON

• Cut off the power supply main switch.

• Clean the air filters and other parts

• Leave the fan running for 2-3 hours to dry out the inside of the unit.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 31 32

No comments

Whirlpool AMD 383 Instruction for Use Page 17