Whirlpool KGCP463 User Manual download pdf (Page 15)

GRIDDLE MODULE

Clean the griddle shortly after removing food and the burner has

been turned off.

■

Use a metal spatula to scrape reside into the drip tray. To

avoid damaging the surface, always rub in the direction of the

polish lines. If necessary, scrub the griddle surface with a

nonabrasive pad and a little cooking oil or use a griddle

screen cleaner (not supplied with this unit).

■

Hot, soapy water and/or soft plastic scrub pad.

■

After cleaning, dry surface with a soft cloth or sponge. To

protect the finish and prevent rust, wipe the entire surface

with a light film of cooking oil.

Drip Tray and Area Under Tray

Allow cooktop to cool completely before cleaning.

■

Soap and water or nonabrasive cleanser.

■

Damp cloth or nonabrasive pad.

TILE BEZEL FEATURE

The Tile Bezel feature allows you to insert decorative tiles into the bezel assembly. This allows you to coordinate the tiles in the bezel

with the tiles in your kitchen. To order additional Tile Bezels, see “Assistance or Service” section.

To Insert Using a

4¹⁄₄

in. (10.8 cm) tile

Before inserting the tile, remove tile bezels from accessory box

and unwrap.

Remove the piece of square cardboard from inside the bezel

and save.

Insert your tile into the bezel with decorative side facing the

front.

Depending on the thickness of the tile, use the cardboard or

the foam tape. Either option will require peeling the backing

off the tape and attaching to the tile.

If you are using cardboard, be sure to center on the tile.

Reattach assembly to control panel by lining up holes on

back of bezel over screws on the control panel, and push

down firmly until it is in place.

To Insert Using a 3

⁷⁄₈

in. (9.8 cm) tile

Before inserting the tile, remove tile bezels from accessory box

and unwrap.

Remove the piece of square cardboard from inside the bezel

and save.

Peel backing from foam tape and adhere to inside vertical

surfaces of tile bezel.

Insert your tile, decorative side facing the front, into one

corner of the bezel and apply some pressure which will

compress the foam tape and allow the other end of the tile to

drop in.

Depending on the thickness of the tile, use the cardboard or

the foam tape. Either option will require peeling the backing

off the tape and attaching to the tile.

If you are using the cardboard, be sure to center on the tile.

Reattach assembly to control panel by lining up holes on

back of bezel over screws on the control panel, and push

down firmly until it is in place.

Pre-Bezel Assembly

Tile

Cardboard

Tile Bezel

Foam Tape

Final Bezel Assembly

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 35 36

Comments to this Manuals

No comments

Whirlpool KGCP463 User Manual Page 15

Comments to this Manuals

Related products and manuals for Cookers Whirlpool KGCP463