Whirlpool W10115228B User Manual download pdf (Page 9)

†®TEFLON is a registered trademark of E.I. Du Pont De Nemours and Company.

Elevations above 10,000 ft. (3,048 m):

When installed above 10,000 ft. (3,048 m) a 4% reduction

of the burner B.T.U. rating shown on the model/serial

number plate is required for each 1,000 ft. (305 m)

increase in elevation.

Gas supply pressure testing

The dryer must be disconnected from the gas supply piping

system during pressure testing at pressures greater than

1/2 psi.

Electrical Requirements

N 120 Volt, 60 Hz., AC only, 15- or 20-amp fused electrical

supply is required. A time-delay fuse or circuit breaker is

recommended. It is also recommended that a separate circuit

serving only this dryer be provided.

GROUNDING INSTRUCTIONS

SAVE THESE INSTRUCTIONS



"

" 

!!

" 

"! 



"

!



WARNING:



!  

"!"

"" !

"! 

"

Option 1 (Recommended Method)

Flexible stainless steel gas connector:

If local codes permit, use a new exible stainless steel gas

connector (Design Certied by the American Gas Association

or CSA International) to connect your dryer to the rigid gas

supply line. Use an elbow and a 3/8" are x 3/8" NPT adapter

tting between the stainless steel gas connector and the

dryer gas pipe, as needed to prevent kinking.

Option 2 (Alternate Method)

Approved aluminum or copper tubing:

Lengths over 20 ft. (6.1 m) can use 3/8" approved tubing

(if codes and gas supplier permit).

If you are using Natural Gas, do not use copper tubing.

3/8" are x 3/8" NPT adapter tting between dryer pipe and N

3/8" approved tubing.

Lengths over 20 ft. (6.1 m) should use larger tubing and a

different size adapter tting.

If your dryer has been converted to use LP gas, 3/8" LP

compatible copper tubing can be used. If the total length

of the supply line is more than 20 ft. (6.1 m), use larger pipe.

NOTE: Pipe joint compounds that resist the action of LP

gas must be used. Do not use TEFLON

®†

tape.

Dryer gas pipe

The gas pipe that comes out through the rear of your dryer N

has a 3/8" male pipe thread.

29" Wide Model

1¼"

(32 mm)

9¼"

(235 mm)

A. 3/8" NPT dryer pipe

27" Wide Model

/4"

(159 mm)

/2"

(38 mm)

A. 3/8" NPT dryer pipe

Burner input requirements

Elevations up to 10,000 ft. (3,048 m):

The design of this dryer is certied by CSA International for

use at altitudes up to 10,000 ft. (3,048 m), above sea level at

the B.T.U. rating indicated on the model/serial number plate.

Burner input adjustments are not required when the dryer is

operated up to this elevation.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 47 48

Comments to this Manuals

No comments

Whirlpool W10115228B User Manual Page 9

Comments to this Manuals

Related products and manuals for Electric laundry dryers Whirlpool W10115228B