Whirlpool WED75HEFW Installation Manual download pdf (Page 18)

IMPORTANT: If the protective ﬁlm has not yet been

removed from the dryer, peel the ﬁlm from the dryer door

before proceeding.

Using a T25

screwdriver, remove the 4 screws securing the

door hinge to the dryer and lift up and out to remove the door.

Place the door on a soft towel or other non-scratch surface.

Reinstall the 4 screws in the holes.

Reverse door swing round-shaped door with ﬂat

glass – single handle

#2 Phillips screwdriver

Min. 8" long TORX T25

® †

screwdriver

Tools needed:

†

®TORX and T25 are registered trademarks of Acument Intellectual Properties, LLC.

DOOR REVERSAL (OPTIONAL)

The following instructions are for models with round and

square-shaped doors.

1. Remove door from dryer

2. Move the door strike

Using a T25

screwdriver, remove the 2 screws securing the

door strike to the door frame of the dryer. Rotate the strike

180° and attach to the opposite side of dryer door frame

as shown.

Remove inner door from outer door

Position the door with the inside of the door facing up.

Using a Phillips screwdriver, remove the 10 screws securing

the inner door to the outer door. Lift off the inner door and

set aside.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 27 28

No comments

Whirlpool WED75HEFW Installation Manual Page 18