Whirlpool EB9FVBXWQ01 Use and Care Guide download pdf (Page 7)

Reverse Handles

1. Unplug refrigerator or disconnect power.

2. Using a screwdriver, remove the handle plugs and then the

handles from the left-hand side of the door and remove the

hole plugs from the right-hand side.

3. Insert the hole plugs (from the Reversibility Kit) into the holes

remaining after the removal of the handles.

4. Install the door handles with their handle plugs to the opposite

side of the door.

Remove the Doors

NOTES:

■ Keep the doors closed until you are ready to lift them free from

the cabinet.

■ Provide additional support for the doors while the hinges are

being removed. Do not depend on the door gasket magnets

to hold the doors in place while you are working.

Refrigerator Door

1. Using a hex key, remove the screw attaching the refrigerator

door to the top hinge. Lift the refrigerator door from the center

hinge.

2. Using a flat-blade tool, remove the cabinet hole plug. Set

aside.

Freezer Door

1. Using a hex key, remove the center hinge. See Center Hinge

graphic.

2. Lift the freezer door from the bottom hinge.

3. Remove and discard the two center hinge hole plugs from the

left-hand side of the cabinet.

4. Insert two cabinet hole plugs, from the Reversibility Kit, into

the holes remaining from the removal of the center hinge.

Reverse the Hinges

Cabinet

1. Using a hex key, remove the top hinge and hole plug from the

right-hand side of the cabinet. See Top Hinge graphic.

2. Move the bushing to the opposite side of the cabinet. See

Graphic 2.

3. Turn the hinge over, so that it is facing the opposite direction,

and install it on the left-hand side of the cabinet.

4. Insert the rectangular cabinet hole plug, removed earlier, into

the holes remaining after the removal of the top hinge.

5. Using two or more people, push against the top, front of the

refrigerator to tilt it slightly backward.

6. At the bottom, left-hand side of the cabinet, remove the

plastic cover and the foot. Unscrew the leveler, and using the

hex key, remove the front and bottom foot screws.

NOTE: You may need to use a flat-edged tool to pry the

plastic cover from the foot.

7. At the bottom, right-hand side of the cabinet, remove the

plastic cover and the hinge. Unscrew the leveler, and using the

hex key, remove the front and bottom hinge screws.

NOTE: You may need to use a flat-edged tool to pry the

plastic cover from the hinge.

8. Move the bottom hinge and the foot to the opposite sides of

the cabinet.

9. Using the hex key, place the hex screws into the holes of the

bottom hinge and fasten the hinge to the cabinet. Replace the

plastic cover and reinstall the leveler. See Bottom Hinge

graphic.

A. New hole plugs (from Reversibility

Kit)

B. Handle screws

C. Hole plugs (remove and discard)

A. Cabinet hole plug

B. Top hinge screw

A. Hole plugs (remove and discard)

B. Hole plugs (from Reversibility Kit)

1 2 3 4 5 6 7 8 9 10 11 12 ... 31 32

Comments to this Manuals

No comments

Whirlpool EB9FVBXWQ01 Use and Care Guide Page 7

Comments to this Manuals

Related products and manuals for Fridges Whirlpool EB9FVBXWQ01