Whirlpool ET16EP User Manual Page 4

  • Download
  • Add to my manuals
  • Print
  • Page
    / 12
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 3
Install properly.. .
Allow 3 Inches (7.5 cm] between overhead cab-
inets and the refrigerator top.
Allow at least an tnch (2 5 cm] between the refrrg-
erator condenser and the wall.
Allow 1 z Inch (1 25 cm) on each side of the re-
frigerator for ease of rnstallatron
If the refrigerator is to be against a wall, you mrght
want to leave enough space so the door can be
opened wider
-1 r-“--.-m *v - n.T%*i -1,111 -*WI” I
/,
Level refrigerator-freezer.. . ~~
Right to Raise;
Left to Lower
Leveling screw
Use Screwdriver
to Adjust
1.
To raise front, turn each screw to the rrght
2. To lower front, turn each screw to the left
3. Check with level
Remove sales labels.. .
Remove the Consumer Buy Guide label, tape and
any inside labels before using the refrigerator.
To remove any remaining glue:
I. Rub briskly with thumb to make a ball then remove
OR
2. Soak area with dishwashing detergent solution (1
teaspoon detergent in 1 quart warm water] before
removing glue as descrrbed in step 1
DO NOT USE rubbing alcohol or flammable or
toxic solvents, such as acetone, gasoline, car-
bon tetmchloride, etc. These can damage the
material.
NOTE: DO NOT REMOVE ANY PERMANENT IN-
STRUCTION LABELS INSIDE YOUR REFRIGERATOR.
Do not remove the Tech Sheet fastened under
the refrigemtor at the front.
Clean your refrigerator before using it See clean-
ing instructions on page 8.
Plug it in...
Refri&ator
Power Cord
RECOMMENDED GROUNDING METHOD
A 115 Volt, 60 Hz., AC only 15 or 20 ampere fused
and properly grounded electrical supply is re-
quired. It is recommended that a separate circuit
serving only this applrance be provided.
Do not use an extension cord. Use a recep-
tacle which cannot be turned off wlth a switch
or pull chain. See individual electrical require-
ments and grounding instruction sheet in your liter-
ature package.
4
Page view 3
1 2 3 4 5 6 7 8 9 10 11 12

Comments to this Manuals

No comments