Whirlpool ET18JM Specifications download pdf (Page 6)

Adjusting the refrigerator shelves...

To remove the shelves:

1. First, remove food from shelf.

GUIDE STOP

2. Slide shelf straight out to the stop.

3. Lift front, slide shelf the rest of the way out.

SHELF STOP

To replace the shelves:

1. Fit back of shelf on top of guides with wire stops

on the bottom of guides.

2. Lift front, slide shelf in until it clears guide stops.

SHELF GUIDE

Removing crispers and crisper cover...

To remove the crispers:

1. Slide crisper straight out to the stop, lift front, then

slide the rest of the way out.

2. Replace in reverse order.

To remove the cover:

1. Lift front and remove the cover support.

2. Lift out cover by pulling up and out.

To replace the cover:

1. Fit back of cover into notch supports on walls of

refrigerator, then lower front into place.

2. Replace cover support with the long tab toward

the front. NOTE: If the support needs adjust-

ment, turn base right to raise, or left to lower.

LlFl THE FRONT, THEN THE BACK.

PULL OUT TO THE STOP.

HE FRONT AND PULL AGAIN.

Changing the light bulb...

1. Reach behind the control console to find bulb

2. Remove bulb.

3. Replace with a 40-watt appliance bulb.

Reversing the door swing...

You can change the hinges on your refrigerator

so the doors open the other way. You will need a

#20 Torx head screwdriver. Refer to the instruction

sheet included with your refrigerator.

Ice cube trays...

(Model ETISJK only)

If cubes are not used, they may shrrnk. The mov-

ing cold air starts a slow evaporation. The longer

cubes are stored, the smaller they get.

1. Hold tray at both ends

1 2 3 4 5 6 7 8 9 10 11 ... 15 16

Comments to this Manuals

No comments

Whirlpool ET18JM Specifications Page 6

Comments to this Manuals

Related products and manuals for Fridges Whirlpool ET18JM