Whirlpool GARF06XXMG00 User Manual download pdf (Page 5)

2. Remove and discard the 2 Phillips-head screws as shown.

3. Using a Phillips screwdriver, remove and discard the front leveling

leg on the side of the refrigerator opposite the door hinge as

shown.

NOTE: The front leveling leg on the door hinge side of the

refrigerator should remain in place.

4. Remove the shipping block from between the compressor and

the back of the refrigerator.

1. Shipping block

NOTE: If you want to reverse the door swing, you should do so

before you attach the caster plate. Go to “Reverse the Door Swing”

section.

5. Position the caster plate on the bottom of the refrigerator with

the reinforcement bar to the front and the vent holes to the back.

Align the mounting pins with the holes created by removing the

screws in Step 2.

6. Attach the caster plate to the refrigerator using the (4) #10 x 1 in.

pan-head screws (provided). Start the first screw in the door

hinge corner. Then, start a second screw in the opposite corner.

Finally, start the remaining 2 screws.

NOTE: Do not tighten any screws until all the screws have been

started.

7. Turn the remaining front leveling leg on the door hinge side of the

refrigerator counterclockwise until the leveling leg pad touches

the surface of the caster plate.

1. Phillips-head screws

1. Front leveling leg - Door hinge side

2. Front leveling leg - Opposite side

1. Reinforcement bar

2. Mounting pins

3. Vent holes

1. Leveling leg pad

2. Caster plate

1 2 3 4 5 6 7 8 9 10 ... 27 28

No comments

Whirlpool GARF06XXMG00 User Manual Page 5