Whirlpool GC5SHGXKB00 User Manual download pdf (Page 8)

7. Tighten the two top trim screws.

Base Grille

Style 1:

To remove the base grille:

1. Open the refrigerator and freezer doors 90°.

2. Remove screws from the base grille using a screwdriver.

NOTE: Do Not Remove Tech Sheet that is fastened behind the

base grille.

To replace the base grille:

1. Open the refrigerator and freezer doors to 90°.

2. Position the base grille in front of the refrigerator and replace

the screws.

Style 2:

To remove the base grille:

1. Open the refrigerator and freezer doors to 90°.

2. Grasp the grille with both hands.

3. Lift up and tilt the top of the grille toward you.

NOTE: Do not remove the Tech Sheet that is fastened behind the

grille.

To replace the base grille:

1. Open the refrigerator and freezer doors to 90°.

2. Place the lower clips in the openings in the metal panel.

3. Roll the grille up toward the refrigerator until it snaps into

place.

Leveling Refrigerator

Your refrigerator has a front and rear roller at the base of the

product on each side. All four rollers can be adjusted from the

front of the product. If your refrigerator seems unsteady or you

want the doors to close easier, adjust the refrigerator's tilt using

the instructions below:

1. Check the installation location to be sure that you have the

proper clearance for the refrigerator. See the “Location

Requirements” section. Plug into a grounded 3 prong outlet.

2. Move the refrigerator into its final position.

3. Open the refrigerator and freezer doors to locate the leveling

bolts at the left and right of the refrigerator base. If your

refrigerator has a base grille, remove it (see “Base Grille”

earlier in this section).

NOTE: The yellow (top) bolt will adjust the rear of the

refrigerator, and the silver (bottom) bolt will adjust the front of

the refrigerator.

4. Use a ¹⁄₂ in. (12.70 mm) socket wrench to adjust the leveling

bolts. Turn the leveling bolt to the right to raise that side of the

refrigerator or turn the leveling bolt to the left to lower that

side. It may take several turns of the leveling bolts to adjust

the tilt of the refrigerator.

NOTE: Be careful not to unscrew the leveling bolts too much

when lowering the refrigerator. The bolt head will start to

come away from the refrigerator when in the lowest position.

If the screw does come out of the rear roller bracket, the

compartment access cover on the back of the refrigerator will

have to be removed to reinstall the bolt.

1. Side Trims

2. Top Trim Screws

3. Door Panels

4. Filler Panels

1. Rear Leveling Bolt (yellow)

2. Front Leveling Bolt (silver)

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 47 48

Comments to this Manuals

No comments

Whirlpool GC5SHGXKB00 User Manual Page 8

Comments to this Manuals

Related products and manuals for Fridges Whirlpool GC5SHGXKB00