Whirlpool CGD9150GW Installation Guide download pdf (Page 25)

REVERSING DRYER DOOR SWING (OPTIONAL)

Remove the Door Assembly

Place a towel or soft cloth on top of dryer or work space

to avoid scratching of the surface.

Remove 3 of the 4 screws that hold the door hinge on the

front panel of the dryer. Partially loosen the remaining screw

with keyhole opening and lift the door off the screw.

Lay the door assembly on a previously prepared at surface

with the inside (inner door assembly) facing up, and remove

6 phillips-head screws to release outer door assembly from

inner door assembly.

NOTE: It is important that you remove only the 6 indicated

screws.

4. Lift the inner door assembly off outer door assembly.

5. Remove 4 Phillips-head screws to release center insert from

outer door ring.

6. Lift and rotate center insert 180 degrees.

7. Reassemble the center insert and outer door ring with the

4 screws

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 63 64

No comments

Whirlpool CGD9150GW Installation Guide Page 25