Whirlpool CGD9150GW Installation Guide download pdf (Page 32)

ELECTRONIC CONTROL SETUP INSTRUCTIONS

Diagnostic Codes

If the set-up mode is entered and one of the following has

previously occurred, the appropriate diagnostic code will be

in the display.

Dryer Display Explanation

d 5 Blocked coin 1 or coin drop UI control

circuit failure (coin recognition and

customer display disabled while

blockage persists).

d 9 Voltage detected below 90 VAC for

8 seconds.

d 13 Blocked coin 2 or coin drop UI control

circuit failure (coin recognition and

customer display disabled while

blockage persists).

d 16 Not receiving communications from

installed debit card reader in Enhanced

(Generation 2) Debit mode.

F 01 Dryer motor control circuit error

(cycles and price display disabled until

diagnostic code is manually cleared).

The control doesn’t know if the motor

relay is bad (stuck on), the motor relay

drive circuit is bad (shorted), causing

the motor relay to stay on, or the

motor relay feedback circuit is bad.

F 22 Exhaust thermistor open, temperature

drops below 18°F (>50 k) for 1

minute in Run mode, or immediately

in Factory Diagnostic Mode.

F 23 Exhaust thermistor shorted,

temperature above 250°F (<500) for

1 minute in Run mode, or immediately

in Factory Diagnostic Mode.

F 70 UI is not receiving communications

from CCU (cycles and price display

disabled while error persists or is

manually cleared).

F 71 CCU is not receiving communications

from UI (cycles and price display

disabled while error persists

or is manually cleared).

F 73 UI Microprocessor is not able to read

or verify EEPROM (cycles and price

display disabled until diagnostic code

is manually cleared).

F 74 UI EEPROM memory is a CRC failure

(cycles and price display disabled until

diagnostic code is manually cleared).

Dryer Diagnostic Mode

This mode is entered by pressing COLORS/DELICATES for one

second while in either of the set-up codes 6.xx or 7.xx or with a

diagnostic code present. Diagnostic codes are cleared on entry

and all display segments should ash. If a diagnostic code

persists, it must be corrected before the diagnostic cycle

can be entered.

All Models:

With all segments ashing, the diagnostic cycle is started

by pressing the PERM PRESS button. The cycle consists

of 7 minutes of heat and 1 minute of cooldown.

The COTTON/WHITES button will increment the diagnostic

cycle minutes up to 99, then roll over to 2 minutes. The

COLORS/DELICATES button will cancel this cycle and

exit the diagnostic mode.

Dryer Help Mode

Dryer help mode is entered by pressing the COTTON/WHITES

button while in special pricing option 2.XX. In help mode, the

software revision is displayed. The help mode is advanced by

pressing the PERM PRESS button. See Help Mode Submenu

below for the order in which items are displayed. Press the

COTTON/WHITES button at any time to exit help mode.

Help Codes

Help Code Description

71 Generation 2 debit card

cycle polling message out

of sequence.

74 Generation 2 debit card

remaining balance message

out of sequence.

75 Generation 2 debit card new

card balance message out

of sequence.

88 Invalid messaging state

found in data acquisition

communications comm_

suprv ( ) routine.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 63 64

Comments to this Manuals

No comments

Whirlpool CGD9150GW Installation Guide Page 32

Comments to this Manuals

Related products and manuals for Washer dryers Whirlpool CGD9150GW