Whirlpool WET4024EW Installation Guide download pdf (Page 21)

Remove the screws from a 3/4" (19 mm) UL listed strain relief

(UL marking on strain relief). Put the tabs of the two clamp

sections (C) into the hole below the terminal block opening

(B) so that one tab is pointing up (A) and the other is pointing

down (D), and hold in place. Tighten strain relief screws just

enough to hold the two clamp sections (C) together.

1. Attach power supply cord

strain relief

A. Strain relief tab pointing up

B. Hole below terminal block opening

C. Clamp section

D. Strain relief tab pointing down

Put power supply cord through the strain relief. Be sure that

the wire insulation on the power supply cord is inside the

strain relief. The strain relief should have a tight t with the

dryer cabinet and be in a horizontal position. Do not further

tighten strain relief screws at this point.

2. Attach power supply cord

to strain relief

4-wire Power Supply Cord Connection

IMPORTANT: A 4-wire connection is required for mobile

homes and where local codes do not permit the use of

3-wire connections.

4-wire receptacle

(NEMA type 14-30R)

4-prong plug

Spade terminals

with upturned ends

Ring terminals

Power Supply Cord Connection

Power Supply Cord Strain Relief

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 87 88

No comments

Whirlpool WET4024EW Installation Guide Page 21