Whirlpool W10529641A Use and Care Guide download pdf (Page 16)

TROUBLESHOOTING

f First try the solutions suggested here or visit our website at www.whirlpool.com/product_help - -'_

In Canada www.whirlpool.ca for assistance and to possibly avoid a service call.

If you experience

Possible Causes

Somution

Clothes are not drying The load is too large and heavy Separate the load to tumble freely.

satisfactorily or drying to dry quickly.

times are too long (cont.) Fabric softener sheets are blocking The air outlet grille is just inside the door, behind the lint screen.

the grille. Check that it is not blocked by a fabric softener sheet.

Use only one fabric softener sheet, and use it only once.

The dryer is located in a room with Proper operation of dryer cycles requires temperatures above

temperature below 45°F (7°C). 45°F (7°C).

The dryer is located in a closet. Closet doors must have ventilation openings at the top

and bottom of the door. The front of the dryer requires

a minimum of 1" (25 mm) of airspace, and, for most

installations, the rear of the dryer requires 5" (127 mm).

See the hstallation hstructions.

Cycle time is too short The load may not be contacting the Level the dryer. See the hstallation hstructions. All four dryer

sensor strips on Automatic Cycles. feet should be in firm contact with the floor.

On some models: Clothes are Under certain environmental or installation conditions,

coming out of the Steam Refresh you may experience underdrying.

cycle with damp or wet spots.

The automatic cycle is ending

early.

Change the dryness level setting on Automatic Cycles.

hcreasing or decreasing the dryness level will change the

amount of drying time in a cycle. Hfloads are consistently

ending too early, see also "Changing the Automatic Cycle

settings to increase or decrease drying time."

Lint on load Lint screen is clogged with lint. Clean lint screen before each load.

Stains on load Hmproper use of fabric softener. Add dryer fabric softener sheets at the beginning of the cycle.

Fabric softener sheets added to a partially dried load can

stain your garments. Do not use fabric softener sheets with

steam cycles.

Stains on drum Loose dyes in clothes. Drum stains are caused by dyes in clothing (usually blue

jeans). These will not transfer to other clothing.

The load was not removed from

dryer at the end of the cycle.

Loads are wrinkled

The dryer was tightly packed.

On some models: For steam

cycles, the water is not properly

connected with the dryer.

On some models: Select Steam Refresh Cycle to tumble

the load with water and heat. This cycle is best for smoothing

out wrinkles and reducing odors from dry loads consisting of

wrinkle-free cotton, cotton-polyester blends, common knits,

and synthetics.

NOTE: Refer to garment care label instructions. Dry-clean-only

garments are not recommended.

Dry smaller loads that can tumble freely. Results may also

vary depending on fabric type.

On some models: Make sure water is connected to the dryer.

Check that water inlet hose is connected to both the faucet

and dryer's water inlet valve. Check that the water supply is

turned on.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 39 40

Comments to this Manuals

No comments

Whirlpool W10529641A Use and Care Guide Page 16

Comments to this Manuals

Related products and manuals for Electric laundry dryers Whirlpool W10529641A