Whirlpool 1188018 Specifications download pdf (Page 11)

Option 2--Plaster wall with no molding

If the plastered wall is to be flush with the cabinet and no molding

is used, the wood frame must be set 1/2"(13 mm) into the inside

wall.

AB C

7. Place a 3/4"(2 cm) thick by 2" (5 cm) wide wood strip on the

bottom of the opening against the inside edge.

A. Plastered wall C. Wood frame

B. Inside wall D. Louvers

Installing wood frame

1. Construct wood frame. See "Location Requirements" for

dimensions.

2. Measure outside width and height of frame to determine wall

opening dimensions.

3. Cut opening through the wall. Remove and save insulation.

NOTES:

• Dimension for depth depends on wall thickness and type

of molding.

• Do not block louvers in air conditioner cabinet.

• Use 1" (2.5 cm) or heavier lumber for wood frame.

14 A -_

A. Outside width

B. Outside height

C. Depth

4. Apply wood preservative to the outside exposed surface.

5. Insert the frame in the wall opening. Square and level frame.

6. Attach frame securely to the wall.

A. ! 7¼" (43.8 cm)

B. 2" (5 cm) wide

C. _" (2 cm) thick

D. Indoor side of wall opening

Center the tray back in the opening and align it with the inside

edge of the opening. Using the 2 inside screw holes in the

tray back, mark screw locations for mounting the

SMART-MOUNT TM tray.

A. Flush with inside wall

A. Inside screw holes

B. Indoor side of wall opening

Remove the tray back. Using these marks, drill %2" pilot holes

approximately 11/2"(3.8 cm) deep.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 43 44

No comments

Whirlpool 1188018 Specifications Page 11