Whirlpool 1188018 Specifications download pdf (Page 15)

If the bottom of the air conditioner does not sit against the

bottom of the SMART-MOUNT TM tray, remove air conditioner

and adjust angle of tray until air conditioner sits against the

bottom of the tray.

A. Air conditioner sitting on SMART-MOUNT" tray

B. SMART-MOUNT" tray

Install screws through the top channel to secure the air

conditioner into the wall opening.

EJectricaJ Shock Hazard

Plug into a grounded 3 prong outlet.

Do not remove ground prong.

Do not use an adapter.

Do not use an extension cord.

Failure to follow these instructions can result in

death, fire, or eJectricaJ shock.

2. Plug into a grounded 3 prong outlet.

3. Press RESET on the power supply cord plug.

1. Trim and seal around the air conditioner on the inside and the

outside.

NOTE: Allow for removal of the air conditioner at a later time

for routine annual maintenance.

AIR CONDITIONERUSE

Operating your air conditioner properly helps you to obtain the

best possible results.

This section explains proper air conditioner operation.

IMPORTANT:

• If you turn off the air conditioner, wait at least 3 minutes

before turning it back on. This prevents the air conditioner

from blowing a fuse or tripping a circuit breaker.

Do not try to operate your air conditioner in the cooling mode

when outside temperature is below 65°F (18°C). The inside

evaporator coil will freeze up, and the air conditioner will not

operate properly.

NOTE: In the event of a power failure, your air conditioner will

operate at the previous settings when the power is restored.

NOTES:

• When the air conditioner is oft, the Room indicator light is lit

and the display shows the current room temperature.

• If the room temperature is below 55°F (13°C), the display will

show 55°F (13°C). If the room temperature is above 99°F

(37°C), the display will show 99°F (37°C).

• When the Set indicator light is lit, the display shows the

temperature control setting. See "Temperature."

• When the Hour indicator light is lit, the display shows the time

remaining on the Timer setting. See "Timer Delay."

1. Remove clear protective film from control panel and front

panel badge.

2. Press POWER to turn on air conditioner.

NOTE: When air conditioner is turned on for the first time

after it is plugged in, it will display the default settings: Cool

mode, Turbo fan speed, 72°F (22°C) for 3 seconds. When it is

turned on at all other times, it will display the previous

settings for 3 seconds, and then display the room

temperature.

3. Select mode. See "Mode."

4. Select fan speed. See "Fan Speed."

5. Set temperature. See "Temperature."

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 43 44

Comments to this Manuals

No comments

Whirlpool 1188018 Specifications Page 15

Comments to this Manuals

Related products and manuals for Split-system air conditioners Whirlpool 1188018