Whirlpool WHD3090GW Installation Manual download pdf (Page 14)

INSTALLATION INSTRUCTIONS

Installation Requirements

TOOLS AND PARTS

Gather the required tools and parts before starting installation.

Tools needed:

Flat-blade screwdriver #2 Phillips screwdriver

Wire stripper (direct wire

installations)

Channel locks

Adjustable wrench that

opens to 1" (25 mm) or

hex-head socket wrench

1/4" and 5/16" nut driver

(recommended)

Utility knife Tape measure

Level

Pliers

If using a power supply cord:

Use a UL-listed power supply cord kit marked for use with

clothes dryers. The kit should contain:

n A UL-listed 30-amp power supply cord, rated 120-/240-volt

minimum. The cord should be type SRD or SRDT and

be at least 4 ft. (1.22 m) long. The wires that connect to

the dryer must end in ring terminals or spade terminals

with upturned ends.

Additional Accessories: (Not supplied with dryer)

Refer to “Operating Instructions” for information about

accessories available for your dryer.

Min. 8" long TORX

T20

®†

screwdriver

†® TORX and T20 are registered trademarks of Acument Intellectual Properties, LLC.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 67 68

No comments

Whirlpool WHD3090GW Installation Manual Page 14