Whirlpool WHD3090GW Installation Manual download pdf (Page 20)

3-wire receptacle

(NEMA-type 10-30R)

3 prong plug

Spade terminals with

upturned ends

Ring terminals

4. Connect remaining wires

Connect remaining wires under outer terminal block screws.

Tighten screws, tighten strain relief screws, and fold insulator

over terminal block. Finally, reinsert tab of terminal block cover

into slot at bottom edge of terminal block housing. Secure

cover with the 2 hold-down screws. Now, go to “Level Dryer.”

3-Wire Power Supply Cord Connection

Use where local codes permit connecting cabinet-ground

conductor to neutral wire.

2. Connect remaining wires

Connect remaining wires under outer terminal block

screws. Tighten screws, tighten strain relief screws,

and fold insulator over terminal block. Finally, reinsert

tab of terminal block cover into slot at bottom edge

of terminal block housing. Secure cover with the

2 hold-down screws. Now, go to “Level Dryer.”

Connect neutral (center) wire (C) of power supply cord

under

center terminal block screw (B)

. Tighten screw.

3-Wire Power Supply Cord Strain Relief:

IMPORTANT: Use the strain relief supplied with the dryer.

Attach power supply cord to strain relief

Put power supply cord through the strain relief. Be sure that

the wire insulation on the power supply cord is inside the

strain relief. Do not further tighten strain relief screws at

this point.

Connect ground wire (F) (green or bare) of power supply

cord under green external ground conductor screw (A).

Tighten screw.

3. Connect ground wire

1. Connect neutral (center) wire

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 67 68

No comments

Whirlpool WHD3090GW Installation Manual Page 20