Whirlpool WHD3090GW Installation Manual download pdf (Page 23)

Place hooked end of neutral wire (white

or center) (C) of direct wire cable under

center screw of terminal block (B), hook

facing right. Squeeze hooked end together. Tighten screw.

3. Connect remaining wires

Place hooked ends of remaining direct wire cable wires

under outer terminal block screws (hooks facing right).

Squeeze hooked ends together, tighten screws, tighten strain

relief screws, and fold insulator over terminal block. Finally,

reinsert tab of terminal block cover into slot at bottom edge

of terminal block housing. Secure cover with the 2 hold-down

screws. Now, go to “Level Dryer.”

Optional External Ground for 3-Wire

Connection (Power Supply Cord Shown)

IMPORTANT: You must verify with a qualiﬁed electrician

that this grounding method is acceptable before connecting.

Remove center terminal block screw (B) and green external

ground conductor screw (A). Loop neutral bonding wire (white)

(D) to center terminal block.

Connect neutral wire (white or center) (C) of power supply cord

or cable under center terminal block screw (B). Make sure

the end of neutral bonding wire (white) (D) looped in Step 1

remains on the center terminal when the power supply cord

neutral wire is attached. Tighten screw.

Place ends of remaining wires under outer terminal block

screws. Tighten screws and tighten strain relief.

3. Connect remaining wires

Connect a separate copper ground wire (G) under the green

external ground conductor screw (A) to an adequate ground.

Fold insulator over terminal block. Finally, reinsert tab of

terminal block cover into slot at bottom edge of terminal block

housing. Secure cover with the 2 hold-down screws. Now, go

to “Level Dryer.”

2. Connect neutral wire

1. Prepare to connect neutral wire

2. Connect neutral wire

4. Connect external ground wire

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 67 68

No comments

Whirlpool WHD3090GW Installation Manual Page 23