Whirlpool WHD3090GW Installation Manual Page 24

  • Download
  • Add to my manuals
  • Print
  • Page
    / 68
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 23
24
Level Dryer
1. Level dryer
Place
level here on
either side
Not Level LEVEL Not Level
Check levelness of dryer from
side to side. Repeat from front to back.
NOTE: The dryer must be level for the moisture-sensing
system to operate correctly. If forward slope of dryer is
greater than 1" (25 mm), water could run out from front
of filter.
2. Adjust leveling legs
If dryer is not level, prop up using a wood block, use wrench
to adjust legs up or down, and check again for levelness.
Once dryer is level, make sure all four legs are snug against
the floor and dryer does not rock.
3. Plug into a grounded 3 prong outlet
Complete Installation Checklist
q
Check that all parts are now installed. If there is an extra
part, go back through steps to see what was skipped.
q
Check that dryer is level. See “Level Dryer.”
q
Check that you have all of your tools.
q
Dispose of/recycle all packaging materials.
q
Check dryer’s final location.
q
Remove any tape remaining on dryer.
q
Wipe dryer drum interior thoroughly with a damp cloth
to remove any dust.
q
Read “Using Your Dryer” in “Operating Instructions.”
q
For power supply cord installation, plug into a grounded
outlet. For direct wire installation, turn on power.
q
Select a Timed Dry heated cycle and start dryer.
If dryer will not start, check the following:
• Controls are set in a running or ON position.
Start/Pause button has been pushed firmly and held for
3 seconds.
Dryer is plugged into an outlet and/or electrical supply.
Household fuse is intact and tight or circuit breaker has
not tripped.
• Dryer door is closed.
This dryer automatically runs an installation diagnostic routine
at the start of its first cycle.
NOTE: You may notice an odor when dryer is first heated.
The odor will go away.
Page view 23
1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 67 68

Comments to this Manuals

No comments