Whirlpool AWG 870 Instruction for Use download pdf (Page 12)

INSTALLATION

Remove the transit bolts

1.Slacken the three or four bolts (according to model) with

the spanner supplied.

2.Unscrew the bolts by hand.

3.Hold the screws together with the plastic spacers and

remove them.

4.Close the holes with the plastic covers (supplied with the

documents).

5.Keep the transit bolts for future use.

If the plastic spacers remain inside the machine: Open the

rear panel by removing the twelve screws, remove the

spacers and replace the panel.

Fit the transit bolts before transporting the appliance as

follows:

1.Pry off the plastic covers with a screwdriver and remove

them.

2.Insert the transit bolts, performing the steps for removal

in reverse order.

Adjust the feet

If the floor is uneven, adjust the levelling feet as required

(do not insert pieces of wood, cardboard etc. under the

feet):

1.Loosen the locknut using the wrench provided.

2.Adjust the height of the foot, turning it by hand.

3.Tighten the locknut anticlockwise towards the washing

machine.

If the appliance is to be installed on a wooden floor, distribute

the weight by placing it on a 60 x 60 (40) cm sheet of plywood

at least 3 cm in thickness.

Secure the plywood sheet to the floor.

3gb20003.fm5 Page 66 Thursday, January 3, 2002 9:46 AM

Black Process Plate

1 2 ... 7 8 9 10 11 12 13 14

No comments

Whirlpool AWG 870 Instruction for Use Page 12