Whirlpool 9700S User Manual download pdf (Page 19)

2-10

When connecting to the terminal block, place the hooked end of

the wire under the screw of the terminal block (hook facing right),

queeze hooked end together and tighten screw, as shown.

Loosen or remove center silver-colored terminal block screw.

Place the hooked end of the neutral wire (white or center wire)

of direct wire cable under the center screw of terminal block

(hook facing right). Squeeze hooked end together. Tighten

screw.

Place the hooked ends of the other direct wire cable wires

under the outer terminal block screws (hooks facing right).

Squeeze hooked ends together. Tighten screws.

Tighten strain relief screw.

Insert tab of terminal block cover into slot of dryer rear panel.

Secure cover with hold-down screw.

You have completed your electrical connection. Now go to

“Venting Requirements.”

123456789495663456

Remove center silver-colored terminal block screw.

Remove neutral ground wire from external ground conductor

screw. Connect neutral ground wire and the neutral wire

(white or center wire) of power supply cord/cable under

center, silver-colored terminal block screw. Tighten screw.

Connect the other wires to outer terminal block screws.

Tighten screws.

Tighten strain relief screws.

Connect a separate copper ground wire from the external

ground conductor screw to an adequate ground.

Insert tab of terminal block cover into slot of dryer rear panel.

Secure cover with hold-down screw.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 74 75

No comments

Whirlpool 9700S User Manual Page 19