Whirlpool 9700S User Manual Page 20

  • Download
  • Add to my manuals
  • Print
  • Page
    / 75
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 19
2-11
1234 536 7 2895 223 4
7
To reduce the risk of fire, this dryer MUST BE
E
XHAUSTED OUTDOORS.
Observe all governing codes and ordinances.
The dryer exhaust must not be connected into any gas vent,
c
himney, wall, ceiling or a concealed space of a building.
953632 5453623442
Clean lint from the entire length of the system and make sure
exhaust hood is not plugged with lint.
Replace any plastic or metal foil vent with rigid or flexible
heavy metal vent.
Review Vent system chart. Modify existing vent system if
necessary to achieve the best drying performance.
4553223442
1234 4 2 5
Use a heavy metal vent. Do not use plastic or metal foil vent.
4" (10.2 cm) heavy metal exhaust vent and clamps must be
used.
Vent products can be purchased from your dealer or by
calling Maytag Services. For more information, see the
?Assistance or Service? section of this manual.
For best drying performance, rigid metal vents are
recommended.
Rigid metal vent is recommended to avoid crushing and
kinking.
Flexible metal vents are acceptable only if accessible for
cleaning.
Flexible metal vent must be fully extended and supported
when the dryer is in its final location.
Remove excess flexible metal vent to avoid sagging and
kinking that may result in reduced airflow and poor
performance.
Do not install flexible metal vent in enclosed walls, ceilings or
floors.
45° elbows provide better airflow than 90 ° elbows.
Use clamps to seal all joints.
Exhaust vent must not be connected or secured with screws
or other fastening devices that extend into the interior of the
duct. Do not use duct tape.
Recommended hood styles are shown here.
The angled hood style (shown here) is acceptable.
1234546
Page view 19
1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 74 75

Comments to this Manuals

No comments