Whirlpool GC1SHAXM User Manual download pdf (Page 35)

5-1

COMPONENT TESTING

Electrical Shock Hazard

Disconnect power before servicing.

Replace all parts and panels before operating.

Failure to do so can result in death or electrical shock.

The chart below lists all major electrical components and the procedure for checking them. All

continuity/resistance checks should be done with harness connectors unplugged.

COMPONENT

VOLTAGE AT

COMPONENT

RESISTANCE / WATTS

TEST LOCATIONS

Compressor:

Run Windings

Start Windings

120 VAC

Compressor pins:

1 to 5 Ω

3 to 11

See Tech-Sheet

Performance Data Chart.

Start Relay 120 VAC Continuity

Terminals “S” and “R”

Overload Protector 120 VAC Continuity

Between terminals.

Run Capacitor

120 VAC Momentary resistance

Check at capacitor;

reverse test leads and

check again.

Electric Air Bafﬂe

(Motor)

120 VAC

Approx. 8450

Ω, 1.5 Watts

Thermistors:

RC Side

FC Side

Low voltage;

cannot measure

2700 Ω at 77ºF (25ºC)

8750

Ω at 32ºF (0ºC)

RC thermistor at Control

Board pins 4/1 & 4/3.

FC thermistor at Control

Board pins 4/2 & 4/4.

COMPONENT TESTING CHART

Continued on the next page.

WARNING

Check resistance at

Control Board terminals

16/4 & 12/7. During nor-

mal operation, 120V is

present at Bafﬂe termi

nals 1 & 2.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 55 56

Comments to this Manuals

No comments

Whirlpool GC1SHAXM User Manual Page 35

Comments to this Manuals

Related products and manuals for Fridges Whirlpool GC1SHAXM