Whirlpool GC1SHAXM User Manual download pdf (Page 53)

8-1

TECH TIPS

REMOVING THE ORIGINAL GASKET

2. Trim the soft part of the gasket with a

knife around all four sides to expose the

channel where the service gasket will be

mounted.

3. Clean the remaining soft gasket burr from

all sides of the door.

4. Clean the FIP gasket corner from the ﬂash

and burr that was created when the gasket

was manufactured. The service gasket may

now be installed.

NOTE: Replacing the gasket requires trimming

away only the soft part of the original foamed-

in-place (FIP) gasket. Once the soft part of the

FIP gasket is removed, a channel is exposed

to install the service gasket.

To remove the original door gasket:

1. Cut the soft corner section of the FIP gas-

ket.

Upper Soft Part

Of Foamed Gasket

Channel

Soft Burr

Clean Away All Flash

And Burr

1 2 ... 48 49 50 51 52 53 54 55 56

Comments to this Manuals

No comments