Whirlpool Kitchen Aid KAR-19 Service Manual download pdf (Page 17)

2-5

3. Loosen the four 3/8″ hex-head screws on

top of both door hinges.

1. Mounting screws

4. Adjust the hinges so that the door gap is

the same distance at the top and bottom.

5. Check the side door gasket gap. Make

sure that the distance is the same at the

top and bottom. Adjust the hinges, as

necessary.

6. Recheck the front door gap spacing to

make sure that it is properly aligned and

even.

7. Tighten the top hinge screws securely.

8. Reinstall the side door trim.

Door Height Adjustment

Use the following steps to adjust the door

height up or down after the doors have been

leveled.

1. Open the freezer or refrigerator door and

locate the hinge assembly at the bottom of

the door.

1. Locking plate

2. Door stop screw

3. Bushing

2. Use an allen wrench and remove the door

stop screw and locking plate from the

bottom door hinge.

3. Use an open-end wrench and turn the

bushing, located under the bottom of the

hinge, to the left to raise the door, or to the

right to lower the door.

4. Replace the locking plate and door stop

screw. Turn the bushing slightly to align

the hinge and locking plate screw holes.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 75 76

No comments

Whirlpool Kitchen Aid KAR-19 Service Manual Page 17