Whirlpool Kitchen Aid KAR-19 Service Manual download pdf (Page 49)

4-23

REMOVING THE WATER & ICE DISPENSER

Electrical Shock Hazard

Disconnect power before servicing.

Replace all panels before operating.

Failure to do so can result in death or

electrical shock.

NOTE: Sharp edges may be present.

1. Unplug the refrigerator or disconnect the

power.

2. Remove the drip tray from the water & ice

dispenser.

Drip Tray

c) Bow the front panel out at the center

and remove it from the top and bottom

channels of the water & ice dispenser.

Bottom Channel

Top Channel

NOTE: There are two types of water and ice

dispensers: one for doors with panels, and the

other for stainless steel trimless doors. The

front panels for each type of door are removed

differently. Refer to step 3 for paneled doors, or

step 4 for stainless steel trimless doors, to

remove either type of front panel.

4. For stainless steel trimless doors:

a) Position a wood block along the bottom

edge at the left corner of the water & ice

dispenser.

b) Use a rubber mallet, and hit the block

while you pull out at the bottom, so that

the cover tab releases the panel from

the dispenser housing.

Continued on the next page.

Wood Block

3. For paneled doors:

a) Partially open the freezer door.

b) Remove the screws from the freezer

door handle and remove the handle.

d) Proceed to step 5 on the next page to

remove the dispenser.

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 75 76

No comments

Whirlpool Kitchen Aid KAR-19 Service Manual Page 49