Whirlpool Kitchen Aid KAR-19 Service Manual Page 59

  • Download
  • Add to my manuals
  • Print
  • Page
    / 76
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 58
5-5
Electrical Shock Hazard
Disconnect power before servicing.
Replace all panels before operating.
Failure to do so can result in death or electrical shock.
MAIN CONTROL BOARD
INPUTS
P4
THERMISTORS
P3
DISPLAY BOARD
P2
120 VAC SUPPLY
P5
P7
OUTPUTS
P6
OUTPUTS
1
1
2123
123
4
34
5678
2345
1
2
345
1
2
345
109876
Refer to page 4-4 for the procedure for servicing the main control board.
NOTE: See the chart for the main control board test specifications.
PLUG PIN # DESCRIPTION
OUTPUT
CONDITION
1 Communication Line N / A
2 Display Voltage 12 VDC
Measured at pins 2 & 3
3 GND GND
1 Ref. Thermistor GND
2 Frz. Thermistor GND
3 Ref. Thermistor Output 5 VDC
Measured at pins 1 & 3
4 Frz. Thermistor Output 5 VDC Measured at pins 2 & 4
1 Ref. Door Sw Enable 120 VAC
2 Frz. Door Sw Enable 120 VAC
3 N/A
4 Ref. Door Input 120 VAC
Voltage present when door
is o
p
en
5 Ice Maker Valve Input 120 VAC
Voltage present when ice
maker is ener
g
ized
6 Dispenser Valve Input 120 VAC
Voltage present when
dis
p
enser valve is ener
g
ized
7 Bimetal Input 120 VAC
Voltage present when
bimetal is closed
8 Frz. Door Input 120 VAC
1 AC GND AC GND
2 AC L1 120 VAC
3 AC Neutral AC Neutral
4 AC Neutral AC Neutral
5 AC L1 120 VAC
1 Condenser Fan 120 VAC
Voltage present when
condenser fan is on
2 N/A
3 N/A
4 Defrost Heater 120 VAC
Voltage present when
defrost heater is on
5 Ice Maker Enable 120 VAC
Voltage present when I/M
bail arm is down & I/M is
active
1 Air Door
2 Air Door
3 Compressor Drive 3 - 6 VDC
Measured at pins 3 & 8
4 Evap. Fan Feedback N / A
5 Evap. Fan Constant 12 VDC Measured at pins 5 & 9
6 Air Door
7 Air Door
8 Compressor Drive 3 - 6 VDC
Measured at pins 3 & 8
9 Evap. Fan Ground Evap. GND
10 Evap. Fan Run Voltage 5 - 12 VDC Measured at pins 9 & 10
P6
P7
P2
P3
P4
P5
Page view 58
1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 75 76

Comments to this Manuals

No comments