Whirlpool Kitchen Aid KAR-19 Service Manual download pdf (Page 46)

4-20

REMOVING THE WATER RESERVOIR

Electrical Shock Hazard

Disconnect power before servicing.

Replace all panels before operating.

Failure to do so can result in death or

electrical shock.

NOTE: Sharp edges may be present.

1. Unplug the refrigerator or disconnect the

power.

3. Use the leveling screws and lower the

refrigerator onto the four rollers.

Base Grille

NOTE: If the water reservoir tubing located

inside the refrigerator compartment becomes

damaged, you can cut and splice a new reser-

voir in its place using two 5/16″ unions

(#4388201). If the tubing located under the

refrigerator is defective, it will be necessary to

remove the unit from its mounting location to

repair it. If that is the case, use the following

procedure.

2. Remove the two screws from the base

grille and remove the grille.

Screw

Tip Over Hazard

Refrigerator is top heavy and tips easily

when not completely installed.

Keep door taped closed until refrigerator

is completely installed.

Use two or more people to move and

install refrigerator.

Failure to do so can result in death or

serious injury.

4. Pull the refrigerator out of its mounting

location.

Leveling Screws

Rear Front

NOTE: The water reservoir and water valve

locations are shown below.

Water Reservoir

Water Valve

Unit Shown Tipped Back 45˚

Leveling Screws

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 75 76

Comments to this Manuals

No comments

Whirlpool Kitchen Aid KAR-19 Service Manual Page 46

Comments to this Manuals

Related products and manuals for Ice cube makers Whirlpool Kitchen Aid KAR-19