Whirlpool ACMT 6533/IX Instruction for Use download pdf (Page 44)

Switching the appliance off

Disconnect your appliance from the electricity supply

before carrying out any work on it.

Cleaning the oven

Never use steam cleaners or pressure cleaners on

the appliance.

• Clean the glass part of the oven door using a

sponge and a non-abrasive cleaning product,

then dry thoroughly with a soft cloth. Do not use

rough abrasive material or sharp metal scrapers

as these could scratch the surface and cause the

glass to crack.

• The stainless steel or enamel-coated external

parts and the rubber seals may be cleaned using

a sponge which has been soaked in lukewarm

water and neutral soap. Use specialised products

for the removal of stubborn stains. After cleaning,

rinse and dry thoroughly. Do not use abrasive

powders or corrosive substances.

• The inside of the oven should ideally be cleaned

after each use, while it is still lukewarm. Use hot

water and detergent, then rinse well and dry with

a soft cloth. Do not use abrasive products.

• The accessories can be washed like everyday

crockery, and are even dishwasher safe.

• Dirt and grease should be removed from the control

panel using a non-abrasive sponge or a soft cloth.

•

Stainless steel can be marked by hard water that

has been left on the surface for a long time, or by

aggressive detergents that contain phosphorus.

We recommend that the steel surfaces are rinsed

well then dried thoroughly.

Inspecting the oven seals

Check the door seals around the oven regularly. If the

seals are damaged, please contact your nearest After-

sales Service Centre. We recommend that the oven is

not used until the seals have been replaced.

Cleaning the glass ceramic hob

• It is usually sufficient simply to wash the hob using a

damp sponge and dry it with absorbent kitchen roll.

• If the hob is particularly dirty, rub it with a special

glass ceramic cleaning product, then rinse well and

dry thoroughly.

• To remove more stubborn dirt, use a suitable scraper

(this is not supplied with the appliance). Remove

spills as soon as possible, without waiting for the

appliance to cool, to avoid residues forming crusty

deposits. You can obtain excellent results by using a

rustproof steel wire sponge - specifically designed for

glass ceramic surfaces - soaked in soapy water.

• If plastic or sugary substances have accidentally

been melted on the hob, remove them immediately

with the scraper, while the surface is still hot.

• Once it is clean, the hob may be treated with a special

protective maintenance product: the invisible film left

by this product protects the surface from drips during

cooking. This maintenance should be carried out

while the appliance is warm (not hot) or cold.

• Always remember to rinse the appliance well with

clean water and dry it thoroughly: residues can

become encrusted during subsequent cooking

processes.

Glass ceramic hob cleaners Available from

Window scraper Razor blade

scrapers

DIY Stores

Replacement blades DIY Stores,

supermarkets,

chemists

COLLO luneta

HOB BRITE

Hob Clean

SWISSCLEANER

Boots, Co-op stores,

department stores, Regional

Electricity Company shops,

supermarkets

Care and maintenance

Replacing the oven light bulb

1. After disconnecting the oven

from the electricity mains, remove

the glass lid covering the lamp

socket (see  gure).

2. Remove the light bulb and

replace it with a similar one:

voltage 230 V, wattage 25 W,

cap E 14.

3. Replace the lid and reconnect the oven to the electricity

supply.

Do not use the oven lamp as/for ambient lighting.

Do not use abrasive or corrosive detergents (for

example, products in spray cans for cleaning barbecues

and ovens), stain removers, anti-rust products, powder

detergents or sponges with abrasive surfaces: these may

scratch the surface beyond repair.

Side and rear catalytic liners

These are panels coated with a special enamel, which

is able to absorb the fat released by food as it cooks.

This enamel is quite strong, so that the various

accessories (racks, dripping pans, etc.) can slide along

them without damaging them. White marks may appear

on the surfaces; these are not a cause for concern.

Nevertheless, the following should be avoided:

-scraping the enamel with sharp objects (a knife, for

example);

-using detergents or abrasive materials.

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 75 76

Comments to this Manuals

No comments

Whirlpool ACMT 6533/IX Instruction for Use Page 44

Comments to this Manuals

Related products and manuals for Ovens Whirlpool ACMT 6533/IX