Whirlpool WHES40 Troubleshooting Guide download pdf (Page 18)

2. Check the brine tank and brinewell (black tube in salt storage tank) monthly. If hardening is

present, pour small amounts of warm water on hardened areas until they loosen;

3. Be sure to set the correct salt type depending on which salt type is used (NaC1 or KC1).

Use the _ Up or _/ Down buttons to toggle between NaC1 or KC1 and press the O

PROGRAM button to enter information.

4. Press the O PROGRAM button once again to return to normal operating display.

Start a Recharge

Press the O RECHARGE button and hold for three seconds until Recharge begins to flash in the timer

display, starting a recharge. This recharge draws the sanitizing bleach into and through the water

softener. Any air remaining in the water softener is purged to the drain.

If you have questions about installation, programming, operating and routine maintenance...

call 1-866-986-3223, Monday - Friday, 8 am to 9 pm, EST.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 35 36

No comments

Whirlpool WHES40 Troubleshooting Guide Page 18