Whirlpool WHES40 Troubleshooting Guide download pdf (Page 19)

Customize Features/Options

Recharge

Recharge button is used to initiate an immediate recharge.

Press and hold the O RECHARGE button until the words "RECHARGE", "SERVICE"

and "FILL" flash in the display, and the softener enters the fill cycle of regeneration right

away. RECHARGE will flash during the regeneration. When over, full water

conditioning capacity is restored. While water softener is running a recharge, the time

remaining until the recharge is completed will show in the display during all cycles except

for the Fill cycle.

RECHARGE Initiated

NOTE:

Recharge Scheduled

Set Salt Level

Avoid using hot water while the conditioner is regenerating, because the water heater

will refill with bypass hard water.

If you do not want to start an immediate recharge, but would like an extra recharge at the next preset

recharge time, do the following to schedule a recharge.

} " • •

• Press and release (do not hold) the O RECHARGE button. The ",wrds RECHARGE

SCHEDULED" flash in the display, and the softener will recharge at the next recharge

time. The word "RECHARGE" will flash during the regeneration. When over, full water

conditioning capacity is restored.

The water softener has a salt monitor indicator light to remind you to refill the storage tank with salt.

NOTE: You must set salt level each time salt is added to the water softener.

To set this monitor system, lift the salt hole cover and level the salt in the storage tank.

The salt level decal, on the brinewell inside the tank, has numbers from 0 to 8. Observe

the highest number the leveled salt is at, or closest to. Now, press the O SET SALT

LEVEL button until black ovals correspond to the salt level number. At level 2 or below,

the indicator LED will flash "Check Salt Level".

If you want to turn the salt monitor off, press the O SET SALT LEVEL button until

"SALT LEVEL OFF" shows in display.

D.U3,.

!{_.-!3

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 35 36

No comments

Whirlpool WHES40 Troubleshooting Guide Page 19