Whirlpool WHES40 Troubleshooting Guide download pdf (Page 22)

Maximum Days Between Regenerations

The water softener automatically controls regeneration frequency. This provides the greatest operating

efficiency, and under most conditions, this fcature should be left in this mode. However, modify this

feature if you want to force a regeneration every set number of days. For example, if your water supply

contains iron and you want the softener to regenerate at least once every fcw days to keep the resin

bed clean, set the display as shown below. Setting is available from 1 to 15 days by using the UP and

DOWN buttons.

NOTE: The softener will recharge on its own if needed, even if it is before the set number of

days.

1. Press and hold the O PROGRAM button until the following screen is displayed.

i-inn

s_,,i_ U UU

Once in this display, press the O PROGRAM button four times and following display is shown.

This is the automatic (default) setting.

2. Press the _ Up or _ Down buttons to set number of days.

12 or 24 Hour Clock

All time displays are shown in standard clock time (1 to 12 PM; and 1 to 12 AM) at the 12 hr default

setting. If 24 hour clock displays are desired, f()llow steps below.

1. Press and hold the O PROGRAM button until the folk)wing screen is displayed.

i-i t'11-1

s_,,i_ U UU

Once in this display, press the (_ PROGRAM button five times and the fl)llowing display is

shown.

12br= 2qbr

Time Time

12 Hour Clock Initiated 24 Hour Clock Initiated

Press the _ Up or _ Down buttons to set clock.

If you have questions about installation, programming, operating and routine maintenance...

call 1-866-986-3223, Monday - Friday, 8 am to 9 pm, EST.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 35 36

No comments

Whirlpool WHES40 Troubleshooting Guide Page 22