Whirlpool WHES45 Troubleshooting Guide download pdf (Page 18)

Customize Features/Options

Recharge

Recharge button is used to initiate an immediate recharge.

• Press and hold the

RECHARGE button until the words “RECHARGE NOW” flash

in the display. The softener enters the fill cycle of regeneration immediately.

“RECHARGE NOW’ will flash during the regenera tion. When over, full water

conditioning capacity is restored.

RECHARGE Initiated

RECHARGE NOW

NOTE: Avoid using hot water while the conditioner is regenerating, because the water heater

will refill with bypass hard water.

Recharge Tonight

If you do not want to start an immediate recharge, but would like an extra recharge at the next preset

recharge time, do the following to schedule a recharge.

• Press and release ( do not hold) the

RECHARGE button. The words “ RECHARGE

TONIGHT” flash in the display, and the softener will recharge at the next recharge time.

The wor ds “RECHARGE NOW” will flash during the rege neration. When over, full

water conditioning capacity is restored.

P o w e r --- O u t a g e M e m o r y

If electrical power to the water softener is lost, memory built into the timer circuitry will keep all

settings for up to six hours. While the power is out, the display is blank and the water softener will not

regenerate. When electrical power is restored, the following will occur.

You have to reset the present time only if the display is flashing. The HARDNESS and RECHARGE

TIME never require resetting unless a change is desired. Even if the clock is incorrect after a long

power outage, the softener works as it should to keep your water soft. However, regenerations may

occur at the wrong time of day until you reset the clock to the correct time of day.

NOTE: If the water softener was regenerating when power was lost, it will now finish the

cycle.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 34 35

No comments

Whirlpool WHES45 Troubleshooting Guide Page 18