Whirlpool EF 4000-1 IN Instruction for Use download pdf (Page 17)

INSTALLATION

FASTENING THE FRYER AND

BARBECUE

Each appliance is supplied with a set of tabs and

screws to fasten it on units with working surface from

3to4cmthick.

− Cut the unit (as shown in the figure on the previous

page).

− Stretch gasket “D” over the edge of the hole made,

being careful to overlay the junction edges.

− Turn the appliance over and put tabs “A” into the

mountings; only tighten screws “B” a few turns.

Make sure that the tabs are mounted correctly as

shown in the figures at the side. Turn the tabs so

that the appliances can be put into the hole.

− Put the appliance into the hole cut into the unit and

position it correctly.

− Put tabs “A” into place; tooth “C” of the tabs should

go into the hole.

− Tighten screws “B” until the appliance is completely

secured.

− Using a sharp tool cut off the part of gasket “D”

which protrudes from the appliances.

B A

C D

3 cm

4 cm

3 cm

min

1 2 ... 12 13 14 15 16 17 18 19

No comments

Whirlpool EF 4000-1 IN Instruction for Use Page 17