Whirlpool 9700S User Manual download pdf (Page 38)

4-9

Motor Harness Plug

b) Remove the two screws from the belt

switch and remove it from the motor.

Belt Switch Screws

g) Lift the top locking tab of the motor

harness plug and pull the top pins away

from the motor connector, then release

the bottom tab, and remove the plug.

9. To remove the belt switch:

a) Remove the 3/8 inch hex shoulder-

washer screw from the idler pulley as-

sembly and remove the assembly.

h) Remove the two hex washer-head

mounting screws from the drive motor,

then lift the right side of the motor

slightly, pull the two tabs on the left side

out of the chassis slots, and remove the

drive motor.

Top Locking Tab

Idler Pulley Assembly

3/8 inch Hex Shoulder

Washer Screw

Belt Switch

c)Disconnect the blue wires from the belt

switch terminals.

Blue Wire

Hex Washer-Head Screws

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 74 75

No comments

Whirlpool 9700S User Manual Page 38