Whirlpool W10266784A User Manual download pdf (Page 4)

" (1.25 cm)

2" (5.08 cm)

NOTES:

n It is recommended that you do not install the refrigerator near

an oven, radiator, or other heat source. Do not install in a

location where the temperature will fall below 55°F (13°C).

n Normal minimum cabinet cut-out width required for product

installation is 36" (91.44 cm). However, if the product is placed

against an extended wall and the ability to remove the crisper

pans is desired, an additional 18" (45.72 cm) of cabinet width

is r

equired, so a total cabinet opening width of 54"

(137.16 cm) is recommended.

Electrical Requirements

WARNING

Electrical Shock Hazard

Plug into a grounded (earthed) outlet.

Do not remove ground prong.

Do not use an adapter.

Do not use an extension cord.

Failure to follow these instructions can result in death,

fire, or electrical shock.

Before you move your refrigerator into its final location, it is

important to make sure you have the proper electrical connection:

Recommended Grounding Method

A 115 Volt 60 Hz. (Plug 1), 220/240 Volt 50 Hz. (Plugs 2 or 3), or

220 Volt 60 Hz. (Plug 3) AC only 10-amp fused and grounded

(earthed) electrical supply is required.

Plug 1

Plug 2

Plug 3

Plug 4

It is recommended that a separate circuit serving only your

refrigerator be provided. Use an outlet that cannot be turned off

by a switch or pull chain. Do not use an extension cord.

WARNING

Electrical Shock Hazard

Disconnect power before servicing.

Replace all parts and panels before operating.

Failure to do so can result in death or electrical shock.

NOTE: Before performing any type of installation, cleaning, or

removing a light bulb, turn the control, (Thermostat, Refrigerator

or Freezer Control depending on the model) to OFF and then

disconnect the refrigerator from the electrical source. When you

are finished, reconnect the refrigerator to the electrical source and

reset the control (Thermostat, Refrigerator or Freezer Control

depending on the model) to the desired setting.

For Australia and New Zealand:

Your new appliance has been especially man

ufactured to meet all

Australian Standards and Conditions.

Some notations in the installation instructions may refer to

electrical requirements in other countries, so we draw your

particular attention to these specific notes.

Your appliance needs to be plugged into a 230/240 Volt 50 Hz.

10-amp (Plug 4) AC only earthed outlet.

1 2 3 4 5 6 7 8 9 ... 87 88

Comments to this Manuals

No comments

Whirlpool W10266784A User Manual Page 4

Comments to this Manuals

Related products and manuals for Fridges Whirlpool W10266784A