Whirlpool WHD3090GW Installation Manual download pdf (Page 18)

Electric Dryer Power Hookup –

Canada Only

Electrical Requirements

It is your responsibility:

n To contact a qualiﬁed electrical installer.

n To be sure that the electrical connection is adequate

and in conformance with the Canadian Electrical Code,

C22.1 – latest edition and all local codes. A copy of the

above codes standard may be obtained from: Canadian

Standards Association, 178 Rexdale Blvd., Toronto, ON

M9W 1R3 CANADA.

n To supply the required 4-wire, single-phase, 120/240-volt,

60 Hz., AC-only electrical supply on a separate 30-amp

circuit, fused on both sides of the line. A time-delay fuse

or circuit breaker is recommended. Connect to an individual

branch circuit.

n This dryer is equipped with a CSA

International Certiﬁed Power Cord intended

to be plugged into a standard 14-30R wall

receptacle. The cord is 5 ft. (1.52 m) in

length. Be sure wall receptacle is within

reach of dryer’s ﬁnal location.

n Do not use an extension cord.

If using a replacement power supply cord, it is recommended

that you use Power Supply Cord Replacement Part Number

8579325. For further information, please reference the

“Assistance or Service” section.

GROUNDING INSTRUCTIONS

SAVE THESE INSTRUCTIONS

■

For a grounded, cord-connected dryer:

This dryer must be grounded. In the event of malfunction or

breakdown, grounding will reduce the risk of electric shock

by providing a path of least resistance for electric current.

This dryer is equipped with a cord having an equipment-

grounding conductor and a grounding plug. The plug must

be plugged into an appropriate outlet that is properly

installed and grounded in accordance with all local codes

and ordinances.

WARNING: Improper connection of the equipment-

grounding conductor can result in a risk of electric shock.

Check with a qualied electrician or service representative

or personnel if you are in doubt as to whether the dryer is

properly grounded. Do not modify the plug provided with

the dryer: if it will not t the outlet, have a proper outlet

installed by a qualied electrician.

Electric Installation – U.S.A. Only

Remove hold-down screws and terminal block cover.

1. Choose electrical connection type

Power supply cord 4-wire receptacle

(NEMA-Type 14-30R):

Go to “Power Supply Cord Connection.”

3-wire direct connection:

Go to “Direct Wire Connection.”

4-wire direct connection:

Go to “Direct Wire Connection.”

Power supply cord 3-wire receptacle

(NEMA Type 10-30R):

Go to “Power Supply Cord Connection.”

NOTE: If local codes do not permit connection of a

cabinet-ground conductor to neutral wire, go to “Optional

External Ground for 3-Wire Connection.” This connection

can be used with either a power supply cord or a direct

wire connection.

2. Remove terminal block cover

Before you start: disconnect power.

4-wire receptacle

(14-30R)

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 67 68

Comments to this Manuals

No comments

Whirlpool WHD3090GW Installation Manual Page 18

Comments to this Manuals

Related products and manuals for Washer dryers Whirlpool WHD3090GW