Whirlpool W10325088A Use and Care Guide download pdf (Page 34)

TROUBLESHOOTING

Doors

To view an animation showing how to adjust and align the doors, refer to the Product Help/FAQ section of the brand website and search

for “door closing and door alignment.”

Water is leaking or dripping

from the dispenser system

NOTE: A few drops of water

after dispensing is normal.

The glass was not held under the

dispenser long enough.

Hold the glass under the dispenser 2 to 3 seconds after

releasing the dispenser lever.

Water continues to drip from

the dispenser beyond the

first few drops.

The refrigerator has just been

installed.

Flushing the water system removes the air from the lines which

causes the water dispenser to drip. Flush the water system.

See“WaterandIceDispensers.”

The water filter was recently

installed or replaced.

Flushing the water system removes the air from the lines which

causes the water dispenser to drip. Flush the water system.

See“WaterandIceDispensers.”

Water is leaking from the

back of the refrigerator

The water line connections were

not fully tightened.

See “Connecting the Water.”

Recently removed the doors and

did not fully tighten water line

connection

See “Refrigerator Doors and Drawer.”

Water from the dispenser is

warm

Water from the dispenser is chilled

to 50°F (10°C).

This is normal.

The refrigerator has just been

installed.

Allow 24 hours after installation for the water supply to cool

completely.

A large amount of water was

recently dispensed.

Allow 3 hours for the water supply to cool completely.

Water has not been recently

dispensed.

The first glass of water may not be cool. Discard the first glass

of water dispensed.

The refrigerator is not connected to

a cold water pipe.

Make sure the refrigerator is connected to a cold water pipe.

See “Water Supply Requirements.”

PROBLEM POSSIBLE CAUSES SOLUTIONS

The doors will not close

completely

The door is blocked open. Move food packages away from door.

A bin or shelf is in the way. Push bin or shelf back into the correct position.

Recently installed Remove all packaging materials.

The doors are difficult to

open

The door gaskets are dirty or sticky. Clean gaskets and contact surfaces with mild soap and

warm water. Rinse and dry with soft cloth.

The doors appear to be

uneven

The doors need to be aligned or the

refrigerator needs to be leveled.

See “Door Closing and Door Alignment.”

PROBLEM POSSIBLE CAUSES SOLUTIONS

WARNING

Explosion Hazard

Use nonflammable cleaner.

Failure to do so can result in death, explosion, or fire.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 121 122

Comments to this Manuals

No comments

Whirlpool W10325088A Use and Care Guide Page 34

Comments to this Manuals

Related products and manuals for Fridges Whirlpool W10325088A