Whirlpool Automatic Ice Maker User Manual download pdf (Page 14)

Removing the Water Valve

1. Disconnect the wiring harness connector

from the water valve solenoid terminals.

2. Disconnect the water supply lines from the

inlet and outlet of the water valve.

3. Remove the two (2) Hex-head screws

securing the water valve to the side of the

cabinet liner.

(Fig. 3-18)

NOTE: Water may be present in these lines.

Have a small pail available to bleed

lines.

Fig. 3-18

Removing the Hot Gas Solenoid

The hot gas valve can be serviced with the unit tilted back in the service position.

1. Disconnect the wiring harness plug from

the solenoid terminals.

2. Remove the hex-head screw securing the

solenoid to the mounting bracket.

(Fig. 3-19)

Fig. 2-19

Screw

Solenoid

The water valve can be serviced with the unit in the installed position by removing the component

compartment cover.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 33 34

No comments

Whirlpool Automatic Ice Maker User Manual Page 14